Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Solid edge cannot access file
Indeed it does. I just removed McAffe and installed free version of AGV. Have been working on SE for approx one hour, no problems!!! Before I could make 1-5 modifications on a drawing and then......Cannot access file and file was gone. Now, no problem, hope it stays that way. Thanks for tips.- TriSilver
- Post #6
- Forum: Siemens: Solid Edge
-
Solid edge cannot access file
Me again No solution to my problem. I in short, its like this. Run SE ST Win 7 No network connection I open a drawing, work on it for a short time, suddenly I get following message: Cannot access file. I cannot save and when closing file the only thing left is a TMP file!!!! Meaning the...- TriSilver
- Post #4
- Forum: Siemens: Solid Edge
-
Solid edge cannot access file
Nice to get a reply, I am not so good at computers and my problem indeed a very disturbing problem. I run Win7, SE version I beileve is V 100 ( how do I see that )? Not working over network connection. Yesterday I went into SE options, file location and cklicked on reset all ( file locations )...- TriSilver
- Post #3
- Forum: Siemens: Solid Edge
-
Solid edge cannot access file
Have a Solid Edge problem, cannot access file Have used SE for some time, however, some time ago a problem occured. Open a drawing. Make a modification If I want to save I get a message: Cannot access file. After closing the file without saving, the file is gone!!!!! Since I have backup of all...- TriSilver
- Thread
- Replies: 5
- Forum: Siemens: Solid Edge
