Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. PeteCod

    6202-2RZ vs 6202-2RS

    So does anyone know if there is a bearing I can safely use in place of the 6202-2RZ? The grinder is well below the maximum speed of the 2RZ. Or does someone know where I can purchase (for a reasonable amount, including shipping) a single 6202-2RZ bearing? Timken makes them, but I cannot find...
  2. PeteCod

    6202-2RZ vs 6202-2RS

    Thank you very much for the replies. The speed of the grinder is 3600 rpm
  3. PeteCod

    6202-2RZ vs 6202-2RS

    Hello everyone! I am trying to replace a bearing in a bench grinder. The bearing that came in it is a 6202-2RZ bearing, and I cannot seem to find many retailers, and when I do, they have very high shipping costs, as they are all outside of the USA. I do, however, see a lot of 6202-2RS bearings...
  4. PeteCod

    Assigning Diameter as Datum Help

    Hello everyone! I am currently trying to add a concentricity tolerance to the center bore of a gear, using the outer diameter as a datum, similar to what is shown here: http://www.gdandtbasics.com/concentricity/ I am using pro/e wildfire 3.0. How do I assign the outer diameter as the datum...
  5. PeteCod

    Explosion (offset) lines/ general explosion problems

    Thank you for the input! With all of that being said, is there anything you can recommend to prevent/resolve the issue? It does not happen all of the time, but has become more and more common as time passes. For this reason, I am inclined to believe that it has to do, in one way or another, with...
  6. PeteCod

    Explosion (offset) lines/ general explosion problems

    So what would cause the corruption? And how do I prevent/fix it? It is happening to all just about every assembly now.
  7. PeteCod

    Explosion (offset) lines/ general explosion problems

    I should also note that most recently, after adding explosion lines to 4 pages, when I clicked "save", the lines on every page other than the current page were deleted.
  8. PeteCod

    Explosion (offset) lines/ general explosion problems

    Thanks for the input. So why has it gotten worse over time? IF that is the case, then wouldn't an uninstall/reinstall remedy the problem for a little while? Also, the 2 other engineers, who have worked here for longer than I have, have never had these issues.
  9. PeteCod

    Explosion (offset) lines/ general explosion problems

    Hello all! To start, I am using Pro Engineer Wildfire 3.0. In the passed 2 or so months, I have been experiencing problems of escalating degrees relating to explosions. I have been creating explosion lines the same way for about 2 years now, and just recently have I started having problems. It...
  10. PeteCod

    Tubular frame joints in Pro E

    I apologize for not responding soon. That project got pushed back and I kind of forgot to come back here. Yes, I am trying to join 3 tubes to a sharp point.
  11. PeteCod

    Tubular frame joints in Pro E

    Hello everyone, I am currently trying to model a tubular frame in Pro E wildfire 3.0. The frame a rectangular prism, and I am trying to model one of the corners consisting of 3 tubes welded together at 90*. I do NOT need to include the actual weld, but rather just the overall shape and geometry...

Part and Inventory Search

Back
Top