Search results for query: *

Thank you for your reply. I didn't recieve an alert notifing me of a response. I am trying to find an optimal pressure in which water and FOGs will seperate. I want to get a working model in ANSYS to see if it is even possible to seperate the two. But in order to model it in ANSYS I need the...

I am working on a CFD model and am having a hard time finding the properties to input them into ANSYS or solidworks. In particularly dynamic viscosity. An help to point me in the right direction would help. Thanks.

Yes! I'm an intern and not very familiar with hex hole tolerances. I've googled what I think should be what I'm looking for but can't find it. Our shaft are wearing down before the internal beating in the rolls due to prior hole sizes bring to big and the shaft rotates wearing down the shaft.

Yes conveyor. I am asking for generic tolerance recommendations. Thanks

I am using a Hex shaft for rollers for a convener, he shaft is 3/4 across flats, however, I can't find the tolerance for the hex coupling for the shaft. Thanks in advance for any help.

tomwalz, the problem is that 10% left as it is fine sand. The majority of the big material settles at the bottom of a tank.

Thank you Compositepro. I'll look into sand filters. They hadn't crossed my mind.

I work for a roofing manufacturing plant and am trying to use recycle water in our cooling section. Currently the water and granules all go down the same drain where we have a loop that circulates all the water back and the granules settle at the bottom. However, I am having trouble filtering...

That is the direction I was leaning towards, just didn't know if there would be a better option. Thanks.

Yes, it is driven by an electric compressor.

What would be the best device to use to monitor energy consumption on compressed air system? I am wanting to monitor at what time we use the most as well as our weekly average.