Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. RobertoA73

    MAST calculation

    Some of you, do you know any formulas to calculate the maximum torque of stem with key shaft?
  2. RobertoA73

    MAST calculation

    They're an alternative metod at the roarks formula to calculate the mast of stem with key. For me the roarks formula is high conservative. Tks Roberto
  3. RobertoA73

    B16.34 - Wall thikhness in local areas (par 6.1.6)

    I don't understand the position of circle. My problem is near the flange hub. If i respect the dimensions of b16.5 for 10" flange and the api 6d bore diameter, the wall thickness isn't respect.
  4. RobertoA73

    B16.34 - Wall thikhness in local areas (par 6.1.6)

    Hello, i have a problem. At the hub interface of flange B16.5 i have a wall thickness less than that minimum body wall thickness shown in table 3A. How considerer the circle area how the thickness is low? TNK Roberto
  5. RobertoA73

    ASME VIII Design By Analysis with Ansys WB 15

    I have to do a stress analysis of a ball valve according to ASME VIII part 5 (Design By Analysis) but i have some doubts. What kind of linearization should be used in Ansys WB 15? Von Mises linearization is correct to use to evaluate membrane and bending+membrane along SCLs? Thanks Roberto

Part and Inventory Search

Back
Top Bottom