Search results for query: *

Hi to all, when I look at my stress-element-nodal results, the fixing edge of my impeller has the often the highest stress in the whole part. Is it possible to erase this edge from the results? Maybe by setting a parameter (there are so much of them...)? I have attached a screenshot. Thanks for...

Hi to all, thank you for your answers. I have now three RBE3-Elements one from first centerpoint to second centerpoint, next one from first centerpoint to first circle-edge, the third from second centerpoint to second circle-edge. (attached is a screenshot from an example). I have set two fixed...

That sounds if it could work, I will try it tomorrow. Thank you very much for your extensively answer.

Hi to all, the stress results of my calculcations of rotation parts are always not as exact as it should be, because I have to make a fixed definition on an edge of the part, most of the time the edge of the most inner diameter. I have heard that there is a possibility to fix a rotation part on...

Hi to all, I often create graphs from node-paths to compare my results. When I save the simulation and fem-file, the path is not saved within the files. Is there a possibility to save the path?

Hi, I used the automatic coupling method for calculating the contact pressure of a large impeller. But there are many nodes left, see attached screenshot. Has anybody an idea how I can solve this...

Hi Tuw, you were right. I merged some faces and therefore I had difficult edge-points. I split the face in two like it was before and then it worked. Thank you very much!!! [bigsmile] Regards, nxprouser

Hi, I merged the edges, checked the element quality, what can I do else? I do not get a failure message, I just cannot select the Target Face. Has anybody an idea? Thank you.

Hi I want to make a dependent mesh, but on one edge the surface goes over the edge and I get an error message when I try to make the dependent mesh. I tried to fix it with the "Merge face" and "Split face" commands, but it is always the same. Has anybody an idea what I can...

Hi, I want to improve my results for the contact force of a impeller-shaft assembly. Therefore I want to align the nodes of the different part faces with the mesh mating condition (mmc). Before I defined a surface-to-surface-contact. When I now set the mmmc I am not able to update my mesh. I get...