Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NASTRAN - 2D-Dependent Mesh...Why am I not able to select the Target Face???

Status
Not open for further replies.

nxprouser

Mechanical
Feb 18, 2015
10
EU
Hi, I merged the edges, checked the element quality, what can I do else?
I do not get a failure message, I just cannot select the Target Face.
Has anybody an idea?
Thank you.
 
Replies continue below

Recommended for you

Hi nxprouser,

You are using the right tool (merging and splitting edge), yet the reason it fail is probably the Master and the Target Face does not have the same amount of edges.

Regards,
Tuw
 
Hi Tuw,
you were right. I merged some faces and therefore I had difficult edge-points. I split the face in two like it was before and then it worked. Thank you very much!!! [bigsmile]

Regards,
nxprouser
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top