Yes, I've already applied profile tolerances to the faces.
The overall surface is a mix of splines which lead to a sort of ovoid-shaped tube.
Profile of a surface is surely the best way, but for the measurement a kind of "reference" axis or point is needed to begin with the measurement. That's...
Hello all,
In your opinion can I give a position tolerance of an axis?
I have defined the axis through 3 angles and one point (defined by 3 coordinates x-y-z), since this axis refers to a complex inclined geometry. So the next step would be the definition of the position tolerance on a...
Thanks to all for your replies.
Partially threaded hole is definitively a fine and cheap solution, but if a completely through hole is requested as in my case, I suppose one of the captive screws suggeste in the links by CoryPad would fit...
Hello,
I am designing an item with 4 screws M6 fastened on 4 through holes obtained on aluminum bores (height = 12 mm) at the respective ends of a flange.
I am evaluating the category of captive screws since for handling reasons I would like to tight the screws on the holes so as to keep them...
