Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. luisgiraldo89

    NX CAM

    Hey Everyone, Does anybody know if their is any private tutors teaching NX CAM in New Jersey? The training that is offered by Siemens you would have to travel. Thanks
  2. luisgiraldo89

    Deleting Bodies

    HI Guys, I currently rand into a problem with a .stp model that was sent over to me. The step model was sent over to me a 1 body assembly meaning i am not able to take out the insert or screw? any ideas how i can go about this? NX8.5 or 10.0? see attached .stp model...
  3. luisgiraldo89

    Milling Cutter

    Hello Guys, I need some help and hope i make it clear to understand. I need to model a 3 flute effective cutter X 1.282" inch AP. with .750 cutting diameter I am having trouble making the pocket from the sample part i made. Can you guys help in making this pocket. In the dropbox link i added...
  4. luisgiraldo89

    UG/NX 8.5 Help Balancing Holes

    The holes are use to place on a balance machine to balance the tool to its right position. I would think it would fall more under this below: "Balance" = opposite positions, which would be redundant after also saying "180 degrees". Each of these interpretations could lead to creating a...
  5. luisgiraldo89

    UG/NX 8.5 Help Balancing Holes

    The hole needs to balanced so it is not always at 180 degrees?
  6. luisgiraldo89

    UG/NX 8.5 Tool Balancing

    Hi all, I am fairly new to NX but i cam upon a small project that i am working on and need some help. 1. Any way for me to balance a tool in NX. 2. I need to make two holes approximately 180 degrees from each other. Please see attachment? 3. When i say 180 degrees it would mean the...
  7. luisgiraldo89

    UG/NX 8.5 Help Balancing Holes

    Hey Guys, is am fairly new to NX just came upon a project that i need help on. I need to make two balanced 180 degree holes for the face shown in the attachment. I am using NX 8.5 can someone help...

Part and Inventory Search

Back
Top