Thanks for the information. But in Nx software, the process seems to be quite tedious. I also use other software, there we can easily fill the angle. Nx should put this in future uploads.
Finally, I was able to create what I wanted. Thanks, everyone for the help. But still, a question exists how to put angle in Helix curve.
Twist Drill (Siemens NX Tutorial)
Mr Cowski you did not understand the issue. I want to know that there is no option to fill a helix angle in the Helical curve tool. So what calculation should I do to get end value diameter? Or there is any way to fill the angle in the tool?
Thanks, everyone for the suggestion after putting the formula in following way, the problem solved:---
fluteReliefSetback = (helixPitch/2)-(diacutter/2)/sin(helixAngle)-(helixPitch*0.03)
There is another problem too in Helix. I do not know how to put a 3-degree angle in the outward direction...
My previous problem has been solved.
send an image is given below.
My next problem is that,I want to write following expression
(helixPitch/2.0)-(("diaCutter"/2)/cos(90-helixAngle))-(helixPitch*0.030)
The resulting value should be following 0.790762 inches
where value for helixPitch=2.38061...
How can I write the following expression in Seimens NX 11 Software?
I want to write following expression ("oal" - "fluteLen" + "diaMajor" * 1.25)
The resulting value should be following 1.98438 inches
where value for Oal=5.5 in, fluteLen=4.0625 in, diaMajor=0.4375 in
Please help me in this...
When I give the thread on my model by the Thread tool, it not shows in rendering environment, but the Solid Edge software it visible properly. I am sending the two images of my model.
Please tell me what I do...
