Dear Gtaw,
thanks for your reply. I also asked a NoBo in charge to release PED certification and I would like to share with you its feedback. First of all is the Manufacturer of the Vessel that shall authorize such activity. Once I will receive the OK to proceed I can grind the excess of...
Good morning,
due to an excess of penetration in the weld of a nozzle connection, is not possible to insert the floating part of the level switch inside the vessel. The vessel was hydrotested and certified by third party for PED certification. Can I grind the excess of penetration without...
Hello everybody,
Could you please help me to define the torque to be applied on bolts for flange connections. I have several different material (A320 B7/L7 A193 B8) and I would apply 50% of yeld. I shall give evidence to my Client that applied torque is ok, if you can please provide some...
Thanks Mike/DSB123,
I will check with supplier if warranty will remain valid in case of re-working and I'll decide how to proceed.
Thanks a lot for your support.
Dear Mike,
thanks a lot for your answer. In terms of certification what shall I do? Shall I prepare a declaration for flange conversion to be attached to original certificate or it's not necessary? It's just prevent Comments from my Client....
Thanks for your support.
Good morning everybody,
I am new in the forum and this is my first post.
I have purchased some flanges A350 RF. Due to the re-design of the platform, such flanges should be installed in a piping class where FF finishing is required. We would machine the flange face in order to get flat face...
