Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. ocleverley

    Create a groove consistent with a milling cutter

    Ferdo, it's more creating the sweep to make a solid that's limiting at the moment. Harun, Oh that's great, I didn't realise I could get some control lines. Presumably from the "Location Values" tab? It looks like it's only for straight lines through, not a profile. I'll have a play over the...
  2. ocleverley

    Create a groove consistent with a milling cutter

    Hi, I'm trying to model a groove on a curved surface that is to be made on a 5 axis. I only know how to sweep a 2d Sketch which when going around radii smaller than that sketch width causes a clash and cusp error. (see below) In real life this isn't a problem because we are just cutting away...
  3. ocleverley

    Wrap a sketch onto a surface

    Hi, I'm looking to wrap a sketch onto a surface to so that it retains it's dimensional constraints. ie if I sketch 5 lines with 1mm spacing and project onto a curved surface it should retain 1mm spacing. Right now the project command is just doing the same as extruding the sketch through the...
Back
Top