Search results for query: *

Dear engineers, My Sematic HMI 1st Generation KTP400 Basic Mono NP is broken, i have the back up file which is in .psb format. I already purchased the second generation which is KTP 400 Basic. I tried to migrate the HMI project which is the backup file in .psb format by using Wincc and also...

Dear Sirs, I hope this thread finds you well. We have a ABB VFD ACS800-01--0030-5+D150+E200+L502+N653 +P001 , some parameter groups do not show up on the local control panel, the only parameter groups that show are 10, 11, 14, 16, 33 the rest do not show. And also the language selection...

Dear Engineers, I urgently need the manual as well as the control signal line diagram for WEFU / WEICHIA / Engine Speed Controller - Model No. 100 1904 116A. It's a part of Diesel Genset. Kindly check the attached nameplate photos for the Genset as well as the speed controller. The details...

Hello dear fellows, I need your help please, A power generation plant consists of 3 steam turbines each ( 4.8 MW - 6600 V - 50 Hz ) these turbines feed a network of an oil facility which demand currently 7 MW and when all equipment it demands 11 MW but mainly demand 7 MW. This power plant is...

Hello everyone , I am a new power plant operator and I need your consultation please, What will happen to 5.7 MW / 4.16 KV / 60 HZ Standby generator used as Continues Generator. It will be loaded with 1.5 MW Winter time, And 2.5 MW Summer time. For unlimited number of hours for the next 4...

MR. DTR, They are owned by Caterpillar Are you Gen-set commissioning engineer ?

Hello everyone , I am looking for a commissioning engineer specialized in Solar turbines T6o. Please anyone with such skill please get in touch. Best regards,

The prime mover is a gas turbine and the generator output capacity is 5.7 MW. It`s supposed to be continuous but the nameplate says it`s standby !

Good morning everyone , I need your urgent consultancy please ! We are in the line of installing and commissioning a new 5.7 M.W power plant. The unit arrived on-site but the CRITICAL ISSUE is the generator duty type !!! It is supposed to be continues but the nameplate says it is Standby ...

Hello all, Would you please tell me if you know Is Limiter manufacturers other than ABB Calor EMAG, for current limiters 11000 V, 3000 A, 50 HZ Best regards, Kevin.