Hello,
I am performing DOE using Adams/Insight on my full vehicle model in Adams/Car. The issue I am facing is - if I simulate the model on SPMM testrig within the Adams/Car interface, it works fine but when I try to simulate the model for multiple trials through Adams/Insight, I get a...
You are correct, Greg. I read through the .msg file again and observed that the model runs for a few timesteps and then the following error shows up that stops the simulation:
****** Performing Quasi-Static Simulation ******
---- START: ERROR ----
Number of new element states 0 doesn't match...
Error: 'Number of new element states 0 doesn't match number of old ones, 1' solved...
Whoever gets this same error in the future maybe check this:
The issue might be - redundant constraints in your model.
Check for those in Tools > Model Diagnostics > Model Verify
Okay, after going through the .msg file, it seems like even after the compliance matrix calculation fails multiple times, iterations are carried out in subsequent iterations. But then here is the actual error after which the simulation stops.
****** Performing Quasi-Static Simulation ******...
I built a full-vehicle model making minor changes to the in-built macpherson strut template. The model runs fine on the SDI testrig but gives me a 'Compliance matrix calculation failed' error on SPMM testrig.
On SPMM, the SVC is simulated and then the Solver carries out 4-5 iterations before...
