The controlling loads are going to be the axial load on the channel, but it can be either in tension or compression.
In tension typically about 2 kips and in compression it varies a lot so about 10 - 20 kips or so.
Hello,
How exactly do I calculate the effective bending line on a base plate like shown below?
I've read that there are 45 degree projection lines that comes from the bolts. What about the farther bolt from the bend line? Is that one also projecting and therefore causes a larger line?
Visually...
I appreciate all the replies. This is some really good information.
I typically don't account for corrosion rates in the rods since we do galavanize anyway, but I have a DOT asking about it (and rightly so) as it is a critical part of the system. Also, I think they just want to see more numbers...
Hi.
I'm working on a wall design that involves using steel anchor rods (0.75" diameter, threaded) attached to a metal deadman corrugated sheet.
I'm looking to account for corrosion loss in the diameter of steel rod, but I'm not sure on what resources/equations would apply to this type of...
