As i mentioned before， you always give your conclusion easily without proof.
Let me tell you what the part apply for, then you can keep away from discussing it with me.
The part is a C-pin to ensure in the process of moving and fixing the mold, it can keep normal alignment, so as to avoid the...
I just showed my attitude to different characters.
Also, tell me if my signature or other aspects disobeying forum rules? If i post any mail, phone, or other instant contact？
Let me tell you why i don't share a link cause there's no link, it's found from a PC software.
Next time, it would be...
Before making a judgement, show useful answer first, or it's just a useless answer.
And it's unmatured by putting marketing graduates against engineers.
David
Mechanical project manager
JLFY technology company
Https://www.customized-tech.com
Using CNC drilling can do it with high accuracy.
If by electrical discharge machining, the RA of the inner side of the hold will not be as good as you wish.
David
Mechanical project manager
JLFY technology company
Https://www.customized-tech.com
You can try with http://geluids.net/downloads/presentaties/ISO_12488_1_2012%20-%20Cranes%20-%20wheels%20and%20tracks%20copy.pdf
Not sure if page 24 is what you're looking for, hope that can help you.
David
Mechanical project manager
JLFY technology company
Https://www.customized-tech.com
Hi Raminee,
Silicon material is ok.
The silicon durometer I touched is always from 20A to 80A.
For doing it, the way is to use flow mold instead of injection mold.
(If the material of the similar design is metal, the best way will be bent machining if the R is enough)
Hope that can help you get...
Hi Raminee,
What will be the material of the part you displayed? I'm not asking the mold material.
The different material will decide which way will be used.
David
Mechanical project manager
JLFY technology company
Https://www.customized-tech.com
Hi Raminee,
Just from the drawing, it can be molded as one part.
What's the thickness of it?
David
Mechanical project manager
JLFY technology company
Https://www.customized-tech.com
I think there are two reasons why people always think of 3 small gears.
1: In the same time, the small gears turn more times than the larger gears, each tooth work more and wearing more.
2: The small gear is more likely to failure due to its low tooth contact strength and high sliding rate...
