Jackk,
I figured it out. It's because I was running in cache mode, then saving the file and then opeing it up in design mode. This causes the drawing to want a update because it doesn't recognize the difference in the data sets. But if you maintain the design mode on open then it will not...
Can someone tell me why my drawing needs an update after I've closed it in a fully updated state and then reopened it to find that every view on the drawing needs an update. I work with many different assemblies and this doesn't happen very often but every once ad a while I run into one these...
Is there a way to stop a section view from moving in position on the drawing when it's updated to the latest data. For example I have a section cut that I created on one sheet of my drawing and then copied over to another sheet. And of course once on that sheet I moved it to where I wante it to...
Why do sketches turn black sometimes while your working in a assembly? Even when I change over to design mode the sketch stays black. I've tried shutting down and restarting, but no success. When I open the part in a new window it goes back to normal color configs. Only one part in the assembly...
Catia V5 How do you setup a assembly configuration or orientation. Example- I have a handle assembly that I want to setup a configuration of. One in the open position and one in the closed position. Thanks for any info you can provide.
I have installed it on my laptop. Standard windows XP Setup. 2.8 Mhz Intel chip with 64MB Video memory and .5 GB Ram. It seems to run fine. I havn't had any problems with any other part of the software. It just works for about a 1/2 hour and then it just shuts down. I'm using it for a learning...
When I start Catia V5R13, it will run for about 30 Minutes and then shut down without notice. I've tried to find something under the Tools/Options to disable this. But I have been unsuccessful so far. Any info or direction would be greatly appreciated...