Search results for query: *

anybody know who makes these

i agree drawoh, i dont like sending flat patterns, i think they can cause trouble.

thanks dave. is it better to just send a dxf file of the part and not a flat pattern view in the drawing?

when i create a flat pattern view in a drawing it only shows the bend information, is that all they need to make the part?

i have a part im reverse engineering, its 8mm 304ss, my problem is the part measures 8.3 to 8.5 thick depending on where i take the measurement. is the tolerance for stainless plate that much? if i specify 8mm on my drawing will that be ok?

just mate the pin from the end to the top surface of the hole or use perpendicular planes. this way the pin can move around in the hole but not in and out

how do i get the metric dimensions in the brackets. my sw puts the inches in the brackets

should the metric dimensions be in the brackets? my system puts the inches in brackets

i noticed that the nearside and far side countersink for a threaded hole are different, why is that?