Jboggs : "In the real world a machinist would drill & tap the hole first, and then clean it up with a chamfer if needed. So the thread would go all the way to the top surface, and the chamfer would only remove a little of it."
Are you sure about that ? Take a look at this ...
Hi all,
3DDave : I already tried smaller chamfers but the problem is still there. I understand your point with the cylinder and i guess the second picture i posted is the equivalent to what you are saying. The threads should stop when the cone is reached. The problem is that in this case, i see...
Hi everyone,
I'm assembling some parts in SolidWorks. I added some screws for the tapped holes on the pictures attached to this post.
I can't understand why there is a material conflit between the screw and the tapped hole in the case of tapping from the bottom edge of the chamfer (here is a...
