I watched this playlist on balancing, which doesn't mention trial weight until after identifying the heavy spot location.
I did mean phase.
The blower has not been balanced before.
Personally I've never worked with something like that.
Our device isn't particularly expensive to run, however my question is more about the benifits of using a trial mass. Furthemore, it makes sense that halving the mass would necissitate doubling the radius, but what is my starting point. Does the balancing machine suggest an angle, weight, and...
In a few months, we will be overseeing an on-site rotor balancing job for one of the blowers in our plant. And since I haven’t worked on balancing before, I have a few questions:
1. What is the point of installing a trial weight? Even though the heavy spot can be calculated without it.
2. The...
I know that hydrojetting can be more broad in its application. But is there a difference between the two when it comes to piping? If so, how does one decide which to use?
We have used this sealantt for years, without any issues. But we don't currently have the same one so I'm evaluating another one in stock which has similar properties.
We have a steam turbine rotor in our plant that we need to send out for refurbishment. Hence, I need to provide a SOW for the activity. I've never done a refurbishment SOW before, does the following make sense?
SOW:
- Inspection: Including but not limited to:
As found clearances to be...
Hey there,
I'm a maintenance engineer at a utilities plant. And I need to evaluate the sealant we'll use between the casing halves of the turbine. The turbine inlet steam reaches tempretures between 300-400 celsius. However, the sealant we've always used has a flash point of 150. Would this be...
