Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Turbo V Engine - Exhaust Manifold Design
well, just thinking out loud, but I think most single turbo systems applied to street cars just hack a flange onto one of the exhaust manifolds, and then run a cross pipe about the same diameter as the tailpipes used on the car over to the other side along the bottom of the tranny. This would...- furious70
- Post #4
- Forum: Engine & fuel engineering
-
Turbo V Engine - Exhaust Manifold Design
how much power are you trying to make? If this is a relatively low boost, low hp deal (15psi, 1.25-1.5hp/cu in) then I don't know if it matters that much. Obv. you need a balance tube connecting the 2 sides. I would think trying to get the turbo close to the middle would make the most sense...- furious70
- Post #2
- Forum: Engine & fuel engineering
-
Cam profile design
>>>I have half a mind just to give it away to anyone that >>>wants it. Trouble is, I am not sure it will run on >>>another computer without VB being installed. If you have the full version of VB, you can create an executable out of your program for us all to use. I have the full version and...- furious70
- Post #26
- Forum: Engine & fuel engineering
