Search results for query: *

Specifying a Default Pen Mapping Table The default pen mapping is always used unless another pen mapping file has been created and Pro/ENGINEER has been configured to use it. To specify the default pen mapping, remove any reference to pen table files from the config.pro and PCF files, and remove...

Ok I have my config file set to save these also. Thanks again

That does work. I was looking for a way to preview through pro wildfire, by picking the common space icon, but your way is good also. By the way I posted this question in 3 different forums and you are the only one who answered. Thank you very much Frank

I have done all that you say. I still cannot preview a drawing. How are you previewing yours? That may my problem. Perhaps I don't know the proper way to preview in common space!!!

Hello. I would like to browse my drawings contained within the common space directory before opening, but unfortunately when I click on each drawing no preview is available, so I end up opening drawings just to see the contents. I have my config.pro set to Save_drawing_picture_file embed I...

Sorry, I just looked back at this post and you are right my config.pro is duplicated again. Now I have to figure out which half to keep. I don't know why this is happening. If it happens again I will call Rand, we do have the maintenance agreement.

I worked with UDF's quite a bit in the past back on version 10 and 11. At that time when creating the feature we had several choices with the dimensions. They could be setup as Read/Write, Read only, or you set them so the dimension would not show unless you went back to the starting part for...

I had the same duplicate config problem. I open config.pro in a text editor and deleted the duplicate lines. Works fine now.