Check the following:
When you apply Cyclic Symmetry automatically, ANSYS creates constraint equations automatically between low and high component nodes during solution (first creates them and after checks them).
If any adjacent areas to cyclic ones have any displacement restraint, boundary...
I am using ProEngineer Wildfire connected to ANSYS Workbench. Once imported geometry is not available when switch to Ansys classic. How can be obtained the geometry. Is it possible?
Thank you so much
You could use an external tool as CADFIX to translate any CAD model to Ansys native language. This tool works fine. I use it in my job and results are excellent.
We export it from CADDS5, ProE Wildfire,Catia5v11 & Unigraphics v11 without any problem.
Last realease of CADFIX is v6.0...
Hi.
REcently I have been working by programming Menus in UIDL ANSYS Language for linking with ANSYS macros.
I have read that there are many types of variables to define in any menu (Integers, floats, Chars)
All of them by defining the Typ_Int;Typ_Char.... in corresponding case.
The problem...
The problem is the following one
Let's suppose that we have the following table called "partable":
0 .5 1 1.5
0 11 12 13 14
.5 21 22 23 24
1 31 32 33 34
2 41 42 43 44
Note that Zero Rows & Columns are defined with indexs 0 .5 1 & 1.5
Suppose that I request...
I am using table parameters for applying varying pressure loads over nodes located on areas. I have mapped the area and some values of pressure over the refernce points have been set up on the table.
The problem is that i have to get the initial values of the zero column and zero row (index...