Dear hacksaw and electricuwe
Very Thanks for your kindly reply.
Maybe I'm goiing to try MKS Company (ENI power) if there is any suggetion for us.
Thank you very much again
Regards
Jungo
I'm looking for a cable for 5KW RF Plasma power supply.
The used RF Plasma power supply is made by ENI Company.
I'm going to use the cable to connect the matching box and a moving electrode (not static state).
Is there any special consideration that I need to take care for the purpose?
Thank...
the sepcifications as follows:
Generator?
power?1kW
Output voltage MAX.:1kV
out put frequency range?10 ~ 20 kHz
Mains voltage, standard 100~11OV
Transformer?
performance:1KVA
raise generator's output voltage up to 40kv
stady voltage: 20kv?10~20Hz?
These pins need to be etch some patterns on itself surface. So maybe the traditional way (like abrasive polish) is not suitable to apply?
the pattern's high is about 10um
the quantities i need is about hundred
Is there any efficiency way to do the process?
I have some rollers made by SKH 51 material. Could i use the electrochemical polishing technique to polish the surface of the SKH51 rollers?
SKH 51 (C:0.8~0.9, Cr:3.8~4.5, Mo:4.5~5.5, V:1.6~2.2, W:5.5~6.7)
Meanging of the superclean stainless steel are chemistries for 316L, carbon<0.02%, Mn<0.3%, P<0.04%, S<0.003%, Si<0.5, according to the SEMI SPEC. F-19.
The material via AOD or VOD is usually acceptable for relatively non-conrrosive service. System desingers will often speicfy a "double melt"...
Where I can get the metal-foil samples that made by superclean stainless steel ? like 316L VIM/VAR(double vacuume treatment)
The thickness I need is about 50~100um, the size is about 170mm width.
What's the best surface roughness I can get ?
and I need to know the price and min.order.
Thank...
I need the superclean metal-foil for the research.
the ideal meterial is 316L stainless steel, double vacuum treatment, like vim/var.
i know the material hase widly used in the semiconductor equipment industry, but i can't get the foil type sample that made by 316L VIM/VAR.
the thickness i need...
Thanks, unclesyd.
You help me a lot!
The metal foil i need is SS 304L or 316L¡]VIM/VAR¡^
The surface roughness of these metal foil¡]strip¡^is very important to me¡I¡]Ra below about 0.2um, thinkness is about 0.0005"¡^
I want to know if any commerical product i can buy ? or i should get the...