Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Jagged Edge on SS w/N2 assist
Hello, A burr on one side usually means that the beam is not centered good enough. when cutting stainless it is very critical to have a centered beam!! The other cause for a Burr on one side is Constant Gas Pressure!! if you have a gas gauge mounted to or close to the head, note where the...- Mitsuboy
- Post #8
- Forum: Laser engineering
-
I am in need of peramiters
Hello, You want to be at the bottom of the mat'l when cutting stainless steel add your mat'l thickness and your Z-gap and lower your focus accordingly.. if your flame is more on the orange side then speed up, if it is closer to white Slow down or keep the same feed. White flame can also mean...- Mitsuboy
- Post #7
- Forum: Laser engineering
