Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: AirRider04
  • Order by date
  1. AirRider04

    Weld Penetration

    I know this is probably too broad a question but any thoughts are helpful. Are there any guidlines/standards for acceptable weld penetration? I realize material type, weld wire, etc. do contribute. For instance I have a drawing with a 3/16 bevel weld that states "welds must penetrate amd...
  2. AirRider04

    Animator Video Compression Choice?

    For the Animator Add-on for SW2005 which is the best video compressor to use? They all probably have pros/cons but which do people use. Cinepak Codec by Radius Microsoft Video 1 Indeo Video 5.11 Full Frame (Uncompressed) Any thoughts would be appreciated. Air
  3. AirRider04

    Fastener Torque vs Clamping Force

    Is there a simple way to calculate torque if the clamping force of a fastener is known(or vis versa). Thanks Air
  4. AirRider04

    Material Comparison

    Application A rubber bushing gets press-fit into the tube (Tube is 6.5" length). The bushing sees a lot of twisting forces. With this material, we're concerned with the material being to brittle & cracking. Should have have said "influence" instead of "impact" - not worried about impact...
  5. AirRider04

    Material Comparison

    Good Day We currently use 1026 ASTM A513-00 Type 5, 6.25" OD x 3/8" wall DOM Round Tube, Normalized with following specs. Yield = 48,330 ksi Ultimate = 71,070 ksi % Elong in 2" = 33.9 HRB = 75-76 Our supplier is out of stock on this material & wants to substitute material with the following...
  6. AirRider04

    Locking Files

    Is there a way of locking/protecting a part/assembly so people can't edit them? Thanks Neil
  7. AirRider04

    Elongation at Break

    Thanks for the help
  8. AirRider04

    Elongation at Break

    I have two materials Mat'l 1 Yield = 70300psi Ultimate = 84800psi Elongation = 14% Mat'l 2 Yield = 76500psi Ultimate = 86000psi Elongation = 26% If i substitute Material 2 for material 1, what impact will the higher Elongation have? Thanks
  9. AirRider04

    Solidworks to Solid Edge

    Can Solid Edge open Solidworks files or do I have to convert the files to a .sat, .step, .igs to open in Solid Edge? Thanks
  10. AirRider04

    Dimension Coloring

    Two simple questions Where do I change the color of a dimension or note in a drawing? and can I set it to keep using that color for new dimensions? Thanks
  11. AirRider04

    Truck Air Ride Suspensions

    I am a new engineer with a company that designs/builds Air Ride Suspensions for trucks. I was wondering if anyone knows of any design/reference books for Air Ride Suspensions specifically or Truck Suspensions in general. Thanks
Back
Top