I also had a lot of crashes.
I observed also crashes when opening a sat file as assembly.
After several attemts to open this sat-file I recognized that 2005 is only crashing with a specific part template.
After recreating that template from an old 2004 template I did not had crashes anymore.
Use equations for those configuration specific document properties:
Instead of writing "SW-Mass@@Default@MT230200.SLDASM" in
the cell write: ="""SW-Mass@@Default@MT230200.SLDASM"""
Then the property stays in the design table.
I am using: =""""&"SW-Mass@@"&$A3&"@x.SLDASM"&"""" in the cell for...
I found some problems in the drawing environment which causes me to wait a few SP's.
- When working with multiple (more than 1) break lines in broken drawing views the distance between the break lines is not maintained. If the distance is set to a small value most of the breaks are overlapping...