Garland,
I looked and there was no "Algor Results" file. Neither was there a "log" file listed under the Report tab as is normally the case. Let me know if you have any ideas based on the problems you observed in prior versions of Algor.
But before I bother you with the model, I'm trying to...
I have the same problem that a user a few years ago had in thread810-79827.
I'm running a MES simulation on a weldment to examine buckling from eccentric loads, etc... Using the BCSLIB-EXT sparse solver (which I was told during MES training is very fast for MES) and a rather course mesh, the...
I'm looking for more information on the fatigue stress-concentration factors(Kf) associated with interference fits. I have a plain shaft (no shoulders in shaft near the press) that is pressed into a hub. The shaft extends beyond hub and is loaded as a cantilever in reversed bending (high cycle)...
Thanks Cory. As you probably know, the link you provided was to a demo version of a DIN spline design program. The demo version only works for a reference diameter of 120mm. So one option is I could buy the program in order to analyze the spline that I'm concerned with.
However, the program...
Is there a commonly accepted method for sizing DIN splines? Or are there any published stress concentration factors? The spline I have in mind is W140x5x26x8f.
I have copies of standard design procedures and stress factors for "American" splines (AGMA, ANSI, etc...)such as given in the...
