Search results for query: *

I am trying to see the fortran code and try to make some changes to the code.

Hi, there: How can I open an obj file in fortran? Thanks.

thanks for you guys information. appreciate it.

Hi,there: I am wondering that is there any general guide on how to decide a low pressure tank's drain size based on the tank's design data, such as height, diameter and capacity? Thanks.

Thanks for you guys response. One pump is protected by a PRV and the other doesn't. What I am assigned to do is to protect, using a PRV, the pipe line after two chemicals mixed from liquid thermal expansion, I am thinking to use the total flow rate of mixed chemicals and pressure to size the...

Hi, everyone: I need to size a PSV for a piping line which has two pumps working in Parallel, two different chemicals transferred by pumps and mixed in the protected pipe. The pumps have different operation parameters. I am going to do Liquid thermal expansion calculation for the protected...

Latexman: Thanks for your help. I will figure it out later. BTW, TOL stands for threadolet and Wol is weldolet.

Latexman: BTW, do you happen to know what are TOL and WOL in piping and fittings? Thanks for your help.

Latexman: Thanks for your response. Actually I have that document on file. But with set pressure and port size I couldn't decide Cv and Cg for the valve we are using. You could decide Cv and Cg with orifice size and set pressure according to a table in the document. So what I am wondering is...

Hi, everyone: what are the port size and the orifice size for Fisher regulator? I am trying to decide Cv and Cg for an on-site regulator, what I have are Fisher S200, body size, port size and set pressure, how can I make a choice? Thanks a lot.

Jim casey: Thanks so much! I really appraciate it.

thanks for you guys help.I appreciate it. JimCasey: the inlet is at 53.2 pisa,280F and outlet is at 29.4psia 240F. inlet fluid is liquid(water)only. Could you help me to run it at flowserve? what are the equations for this case? Thanks lot!

TD2k: yeah, Q is in gpm. Cv is assumed normal Cv. I think it's Is this a single phase non-cavitating liquid.

I am calculating the flow rate through a control valve: steam condensate,liquid, temperature difference between inlet and outlet is about 40 F. Cv=127 Sg=0.924 Delta P=23.8 The equation I am using:Q=Cv*Sqrt(DeltaP/Sg),I got some number real big. I am wondering: am I using the right equation...

Latexman, Thx for your info.

Where can I find Resistance coefficient(K) for 8x8x6 reducing tee? Thanks.

I need to size a PSV for a Condensate Flash Drum. I have some questions: 1)If the fluid is water, do I need to consider a fire scenario for relief valve and how? 2)In the equipment data sheet, the flash drum is shown as:"Insulation: Steel-banded". What does it really mean? Is it fire proof or...

Thanks for your guys quick response. Appreciate it.

hi, there: Does anyone know #/hr, a flowrate unit, used to express max flow rate through a control valve? is it as the same as lb/hr? Many thanks.

thanks, guys. I appreciate it.