Search results for query: *

Will check it out. Thanks

I'm currently drawing a HP separator (with slugcatcher) with baffles for a series of FE tests, I have the designs from the manufacturer, but they're not fully detailed when it comes to the actual baffles. Does anyone have any generic type pictures of this type of arrangement or know where I can...

I'm currently working on an internal flow problem using CosmosFloworks(2005) and was wondering if anyone knows how or if, it is possible to select a external wall face, from the inside, and let the flow pass through it without affecting the main internal flow? Apologies if this sounds a bit...

Thanks Rob768, trial and error, annoyingly, seems the way forward.

I possibly made my first post a bit simple.I am aware of what a basic frequency analysis does. This Geostar feature allows you to input an exciting force and damping qualities and uses the principle of mode superposition. There's just a whole load of other variable options which are making it...

I'm currently 'trying', quite unsuccessfully, I will add, to use this feature. Has anyone any hints/tips to simplfy this process. Basically I'm trying to caculate stress's on a cantilever beam(a simple model, fixed at one end, block mass on other)which will result from its own natural...

Thanks Kellnerp, managed to solve the problem not long after I posted. Didn't realise you had to identify each individual beam on a long section. e.g, instead of meshing 1x10m, it should be 4x2.5m sections. Took quite a while to redraw all the relevant the curves!

I have recently began a model in Geostar using the beam element function. Early simple models e.g fixed cantilever have worked fine. The problem now is that I'm modeling part of a oil platform, this requires 3 different Real Constant sets for different beams. When I got to run the freq...

OK, I'll give it a go. Thanks.

Has anyone else encountered problems whilst probing a cut section on a stress/displacement plot using SW/CW 2006? Sometimes it'll work fine, but ocasionally it wont, I've played aroung with the obvious filters(face,edge,point)but still nothing. Is there possibly another filter I'm not aware off?

Thanks, think I'm going to have to bite the bullet and learn COSMOS/M(Geostar)!!!

Is it possible to mesh two or more parts individually, then put them in an assembly and run a frequency analysis without having to re-mesh?. My PC is struggling to mesh the model as one part due to 'mesh and volume sizes being significantly different'! But through-out the study I have been able...

We have recently purchased COSMOSM, not really had time to get into it yet. Can a point mass be applied to a Exported model from SW/CW in COSMOSM(Geostar)?

I'm currently trying to run a Freq. Analysis on a model of part of a oil platform structure.Due to the sizes envolved(a lot of I-beams), I have had to simplify my model dramatically!. As an outcome, I am trying to simulate the mass loads of decks above the primary deck of analysis(where the...