Search results for query: *

I tried the journal but unfortunately I got error messages similar to those that ExpertNXs' I am working on the journal, I will let you know if I can figure out the problem... Best regards i.

ExpertNX & ufsure thanks for your helpful posts... I am out of office now but I will try both methods as soon as possible and let you know about the results... Thanks again.. best regards.

well actually no... What I am triyng to do is to get the change of the volume (or the rate of the change of the volume) with increasing offset distance. I am trying to do this in NX because as I said the geometry is relatively complex thus I can not calculate it analytically... At the end of...

Hi, assume that I have a solid body with a relatively complex geometry with volume = V what I would like to do is to offset one face deltax and calculate the new volume (Vnew) and write this volume to a file and repeat this step for n times... I assume this is possible in NX but I dont...

I'm vere grateful to all your interest and replies on this subject. I think I got the point. :)

thanks chris, is there a reference document on this? here another example, say we are going apply an adhesive before fastening it, in BOM we listed all three parts, i.e the part 1 (the body) part 2 (the bolt) and part 3 (adhesive, loctite 410 etc) and in the notes we said "Before fastening...

thanks for your replies... well, document xyz clearly identifies the details. I agree that all the materials should be listed on a BOM , but does it really necessary to put a balloon for every part/material listed on a BOM?? thanks.

THE TITLE SHOULD BE HOW TO PRESENT A "LINER" SORRY...

hi, today, I prepared an assembly drawing in which basicly two pieces will be assembled together, the problem is, there should be a liner material in between. The thickness of the liner will be at most 0.1mm. So, what I did is, in bill of material on the drawing I gave the three components...