I know that the surface prep of Aluminium is vital, but the suppliers of adhesive don't seem to agree. Loctite's rep told me to just clean with MEK!
Can Iask for a recommendation ? Please!
Hi guys,
I have some EPDM non slip sheeting that I want to put on the deck of my aluminium (un-anodised) yacht.
Can anyone recommend an adhesive system?
"Assuming the rubber has a density of 1.0 and the Magnetite 5.0 you need 83 weight% filler to get a composite with a density of 3.0 g/cm3."
I can't see how one could get such a high filler loading?
I need to find a filler with an sg of about 12.
Hi,
I have a client who is wanting us to mould parts in a Thermoplastic Rubber with an S.G. of 3.2 (and other parts with even higher SG's).
I have a compounder nearby who can compound the material for me, but he only has experience with Barium Sulphate that will give us an sg of about 3.
any...
Hi,
I need to run a job in HTV Silicone rubber with an SG of about 5.
Any idea of fillers that I could use for this?
I will need something that is reasonably priced and freely available.
It will also need to run through my injection machine.
The part is basically just a carrier, so there isn't much force involved. Room temperature, black(so this would add some stability,no chemicals involved really. It just sits in the wastewater discharge from a sewerage treatment plant and cleans the UV emitting tubes sterilizing the water.
I am...
I have been asked to mould a replacement part that is used in a UV sterilizing plant. The part holds a rubber wiper that cleans the glass UV tube. The part is about 15 mm from the tube so it's getting a really good dose of UV!
The part supplied is made from some kind of fibreglass filled...
I have been asked to mould a replacement part that is used in a UV sterilizing plant. The part holds a rubber wiper that cleans the glass UV tube. The part is about 15 mm from the tube so it's getting a really good dose of UV!
The part supplied is made from some kind of fibreglass filled...
Thanks, but I am concerned about it effecting the properties and I also need the mix to be FDA approved for food contact. Do you know of a metal powder that would meet this?
Anyone know how to make Hot cure Silicone Rubber metal detectable?
We want to mould some seals for a bakery and the parts need to be able to be detected by their metal detector in case they break up and land in the bread.