NX7.5 - Win7 x64
Is it possible to add a drafting unit for centimeters? I see millimeters & meters (as well as inches & feet/inches). Is there a configurable file somewhere to add units like this?
I've also been asked (in the past) for microns. That's an easy one to "fake" in MM units with the...
It is possible to create your own custom crosshatch file, say a xhatch3.chx file, with some custom definition but it is rather difficult. This started because I wanted concrete as a hatch pattern and I'm trying to make my own. Is there any documentation to help guide in this endeavor?
I've...
I've looked at the video for Drafting Plus on the Siemens website and I'm trying to follow along and re-create what's being done in the video. I don't seem to have the same tools available to me. I've looked at my license file and It looks like I should have Drafting Plus (I do have NX Power...
BVR = BOM View Revision. This is an object in Teamcenter that holds the BOM. Your errors shows that someone else has this object checked out which means that you are not allowed to make changes that affect the BOM in Teamcenter. Once checked in, you'll be able to modify as needed.
Check out font factory. You can download it from Siemens.http://files.engineering.com/getfile.aspx?folder=b2192bb9-93e0-49ef-b6b0-4280ae54b0cb&file=fontFactoryDoc.pdf
I was wondering if there was any way to tie a smart note on a drafting sheet a couple different ways.
1st - the counterbored hole - All of the points were placed in a single sketch and the point count is totaled on the top of the Hole dialog at 38. Can I tie a note to that number so that if it...
I was asked the same question and this is what I found on GTAC. Key to note here is "order of creation".
PR Number : 6115832
***** <<<<< This PR has been closed. The resolution was: >>>>> *****
The problem where the sheet Part Navigator order or sheet Properties do not match the title block...
Maybe I don't understand what the purpose of the mold lines (inner and outer) are. I hope that the attached PDF clarifies.
I change flat pattern preferenes to bend CL & tangent lines (slide 1) and I see them. When I turn off bend tangent lines and select inner or outer mold lines I see only...
Thanks for the responses.
The "problem" per se is that i'd like to see the Outer (or Inner) Mold lines on the flat pattern. I cycle through the flat pattern display to see what NX means and will display for Bend Center, Joggle, Interior, etc. When I have Inner or Outer Mold selected and Bend...
I'm working with a group migrating from Ideas to NX5 (5.0.6.3 specifically). I've been presented with the existing work flow and drawings and I'm trying to re-create them in NX. The attached PDF shows a current drawing. Basically showing the flat pattern fully dimensioned with Bend CL's and...
