I was able to do it, but this bad boy was a difficult one
I could not do it using the sheet metal portion, I had to do extrusion and cut extrude the two flanges that form the punch, then I had to insert a bed so it would flatten the punch
Thanks everyone for all your input
Ricardo
well that really sucks then
how about this instead, can you pattern a jog?
I tried it but it did not let me either (now, I would do it if there were only 5 tabs or so, but my part has about 50 and talk about a waste of time trying to draw each one individually)
Thanks for your replies
Ricardo
I am trying to pattern a couple of edge flanges from a part I drew, I am able to pattern a cut extrusion but it does not allow me to pattern the flanges
can this be done?
I am using SW2007
Thanks for your help
Ricardo
can we save any drawings as PDF (.dft, .asm, .par etc)
and if we can how do you do it?
I could not find a way unless is some hidden tool bar
Thanks
Ricardo
How can I set up my SE (version 18) so, the dimensions are shown in fractions (1/4, 1/2, 1/8 and on) instead of decimals (.25, .5, .125 and on)?
Thanks for the feedback