Rearrange your button settings as you like, then Preferences->User interface (i dont remember exactly the menu names but it must seem like this) put a tick to the "save layout on exit" command. next time you start UG you must probably find the appereance as you set. You may untick the...
I have to use Solidworks, i haven't got enough time to learn that prog.
APPENG; I don't need details on part, i need details only in section wiev of the part in draft. Do i have to draw a tooth profile and circ. pattern it? You know it will be great deal to draw an involute profile.. I will...
1- How can i draw a gear in SWX. Can a simple revolve command create a gear, is there any extra step that must be done?
2- How can i find parts library on the net (free of charge)?
3- Can i find a tutorial about SWX (.DOC file or .PDF file or something else)?
Ok. I think i will overcome the face problem. Lastly could you just say the needed teeth numbers for planet:100rpm, carrier:33 or 20 rpm, annulus:fixed. Then the corresponding rotation of sun?.. (Sun will be input but i must get these values as an output) By the way one planet will be used; does...
Sun will be the input yes.. And the planet will be the output, annulus is fixed (sorry i must provide these info). When i take my pinion (planet) 18 teeth, sun 54 teeth, annulus 90 teeth the ratio is -0.6. I didn't give necessary info so you have misunderstood me. I will design the gears, so i...
Do you mean the type of gears by asking "kind of face"? if it is; they will be spur gears. Also i think i've found a start point. I took 3*pitch circle of planet equals 1*pitch circle of sun gear. Thus diameter ratio is 1/3. But i'm still not sure that will i take the pith circle of...
Hi,
I will design a planetary gear train. The planet gear will be connected to a stirrer that applies approximately 100 Nm torque. The center distance between sun and planet must be apprx. 90mm. Planet gear must rotate at 100 rpm. Also carrier arm must rotate 1 time cw. as the planet gear...
