Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. nathan17

    Mazak 0.50 MS cut conditions

    I dont know if this will work on your machine but on my amada X1 i just increase the length of my lead in about 2 - 3 mm to allow the cut to begin better.
  2. nathan17

    cutting 2mm hot rolled stainless steel

    Hi, i'm having some trouble getting cutting conditions right for an AMADA LC 3015 X1 NT. wWe normally use cold rolled stainless but just got some hot rolled in. My normal cold rolled settings will not cut. Settings i use for CR are pwr 4000, frq 1500, duty 99, feed 4200, gas pressure 9 bar (high...

Part and Inventory Search

Back
Top Bottom