Hey everyone, thank you very much for your input and ideas, they all work very well for what I am trying to do. Sorry I did forget to mention I was using NX 6, but it looks like most of you are too.
Mmauldin, when I opened the second part you uploaded for some reason it looked exactly like...
I have two different sketches next to each other in the same plane (see attached .prt file). I'm trying to rotate SKETCH1 along an arc path 180 degress. And as it travels along that path have it gradually transformed into SKETCH2. Essentially, I want it to be like the solid in that file but...
Sorry, I actually just figured out the issue. Turns out it was a lot simpler than I realized. I was measuring one entire cycle coming out of the counter: low to high back to low, whereas the latch was simply waiting for the signal to go from low to high, thus only being half a cycle and...
I am a student, but this is not for school, I'm actually co-oping for an engineering company. This is an issue in our circuitry and we can't figure out what the deal is.
Right now I have a 555 Timer set for 2ms. The pulse feeds into a 74HC40 binary counter. The signal then travels from the counter to a 74HC75 Latch and from there to LED's. The expected timing coming out of the counter is correct (they've been measured with an oscilloscope). However, the LED's...