Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Tipping Load
I must have missed that in my stats class. Thanks for all the info!- Faktor
- Post #5
- Forum: Mechanical engineering general discussion
-
Tipping Load
Here's the problem in basic form: I want to calculate how much load it would take to tip over a light pole structure that is just mounted to a base plate which is not secured to the floor. Basically this is the same kind of problem a portable basketball hoop faces. 1. What is the correct...- Faktor
- Thread
- Replies: 4
- Forum: Mechanical engineering general discussion
-
COSMOSworks and wood
I'm running a model that contains both SS and mahogany wood. I can run cosmos on the SS support and it runs fine. But after finishing the study on the wood I get an error message when I try to run the study that says "please define Elastic modulus in material properties". I've looked at all the...- Faktor
- Thread
- Replies: 6
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Drawing
Ah...just got it to work. Just had to click on the part hit ctrl+c and then paste it into the other sheet. thx- Faktor
- Post #3
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Drawing
I have two drawings on separate files. One of my drawing files has 4 sheets. I want to combine my other drawing into this one on the fifth sheet but can't figure out how to do this. I'm sure there's something simple I'm missing. Using SW08. Thanks- Faktor
- Thread
- Replies: 2
- Forum: DASSAULT: SOLIDWORKS 3D Design
