Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. PrasadReddi

    Will not be tied to the master surface assembly

    Hello, You can use the POSITION TOLERANCE under Tie Contact. Just give a value more than the gap between the Master and Slave under POSITION TOLERANCE in the TIE contact pair. It will certainly work. Hope this will help you. Regards, Prasad
  2. PrasadReddi

    Abaqus - how is plastic behaviour interploated between two adjacent material definitions

    Hi, What I observe about the extrapoloation is, the plastic strain will be validated depending upon the deformed element. So, the Stress will remain constant and the strain will be extrapolated depending upon the deformed shape and the simulation will come out of the extrapoloation is there is...
  3. PrasadReddi

    Need clarification of using EXTENSION ZONE under *CONTACT PAIR

    Dear all, I'm using EXTENSION ZONE varaible under *CONTACT PAIR to consider the contact detection using the extended zone. As per the manual, it is given that the range is 0.0 to 0.2 and if we use ABAQUS CAE for solving, it will impose 0.1 as default. Here my doubt is, if we use an extreme...
Back
Top