Search results for query: *

I am stuck in the design phase - what is a good software program to assist with determining whether the head at the downstream inlets causes a tailwater upstream? Joe B 'Go Buckeyes'

Alright Rob! Do you know how to load them in to ArcExplorer 3.x?

How do you know if the pipes are DOT in charge or not? I need to know if a pipe is the County or the DOT. Thanks.

Rich, I heard the tfw is a file with the geocoordinates of the tiff file. All I need is to load the tiff into MS so I can view the aerial at the right location. Thank you much. Joe

Very cool Rich, thanks. How do I get the coordinates if I don't have a tfw file?? Thanks again - J

Thanks for the site Rob, So once it is in dxf, the file will load into MS at the proper geo-location without additional steps?? Big time thanks - J

Thanks Rich. I will definitely try that. So when do I type/use that command?? Basically I tried pulling it into MS by (reference - attach file). My file looked the same afterwards, I zoomed out looking for the tif. I guess I will type in that command after I do the (ref - attach). I was...

Thanks again flame. For a volume calc, what would be the most accurate way (or preferred) for determining volume between two surfaces. One of my surfaces has less points then the other - I want to use the most effective / useful process for the vol calc. Thanks-

How can I load tif files into MS georefernced?? Is the tfw fie necessary?? Thank you

I need helpful hints with the 3-D issue. Once the surface is loaded what is the steps for getting a 3-D model? Can it be accomplished with the DTM file??

I read some where that .shp(??) files can be loaded into MS. How?? Does the file need to be georeferenced or does it load in at the proper location? Thanks -

Thanks Carl. How would you do this in InRoads?? or MicroStation?? Thank you

Thanks Flame - way cool. I need helpful hints with the 3-D issue. Once the surface is loaded what is the steps for getting a 3-D model? Can it be accomplished with the DTM file?? Thank you.

How do you save a surface so you can modfy it?? How can you view the points already loaded in for a contour surface?? Thank you for the help.