Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. 1cadcam

    Undercut: how to machine it with 3-axis mach. and barrel cutter ??

    Jaydenn, I am using NX5 and NX6. Thank you for your help. I knew it should be simple, but I just wasn't getting it. The part I was missing was the projection vector.....had it set to the Tool Axis, instead of Toward Drive. Your file worked just right. Thank you very much! P.S.-This is a...
  2. 1cadcam

    Undercut: how to machine it with 3-axis mach. and barrel cutter ??

    I am trying to do an undercut with a T-Cutter or a Barrel cutter. I looked at a similar thread in this forum, but was unable to get it to work. The radius of the tool is slightly smaller than the radius in the geometry I am trying to cut (.003" smaller), and I am trying to just do something...
Back
Top