Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. ebroyles

    Solidworks hole callout symbols for CSK, CBORE, DEPTH etc

    Rattler, I think you should be ok. I believe BS8888 Complies to ISO ISO 1101:2005 & ISO 5458:1998. Those sysmbols are acceptable to those standards. So if BS8888 does comply with the ISO Standards you should be ok. e.
  2. ebroyles

    Thread Callouts for Hole Wizard

    ArtL, Actually this is a common practice. I used to work contractually for a billion dollar corporation that was global. This to was their prefered method as well. And it is hard to get a company of that size to change their methods. They to this day still call out threaded holes like that. So...
  3. ebroyles

    Thread Callouts for Hole Wizard

    AnnaWood, We have recently begun migration from NX5 to solid works. This is the system that everyone is accustom to. They would very much prefer to have the same setup. In NX you manually put in the correct decimal size compared to Standard drop down sizes that Solidworks offers. It is merely a...
  4. ebroyles

    Thread Callouts for Hole Wizard

    RussellBucyrus, Thank you for the information. But I my question might of been misleading I have attached a file to show what we would like to see as decimal. I hope this helps to clarify my issue. Thanks again...
  5. ebroyles

    Thread Callouts for Hole Wizard

    Hi all, I have been looking around on the forum and I wasn't able to find anything really definative to answer my question. I was curious if there is a type of setting or toggle I could change to show the Hole Wizard Size (Under Hole Specifications) as decimal instead of fractional. I know it...
Back
Top