Actually stumbled upon babel3d.com and it had the option to convert step to obj, pretty handy site. Thanks for your response!
-Concordia res parvae crescent-
Hey Gupta,
Yeah I've been using Photoview 360, it's not bad but I would like to try some other software, alot of them only take these certain formats.
-Concordia res parvae crescent-
Unfortunately it does not, it is a rendering program and only supports the formats stated above. Thank you both for your help.
-Concordia res parvae crescent-
I would like to be able to export or save as from Solidworks in one of the following formats; .kzx, .xml, .3ds, .obj, .sia. Also, and here's where it gets tricky, I'm looking for a free add-in. Software that converts something Solidworks can save as to one of those formats would also be nice...
Hello everyone,
I modeled up a geneva drive mechanism and I am having troubles trying to find a way to mate it properly in SW09. I figured you guys could help shed some light on this. Is it even possible? You can download my assembly from the attached link if you would like.
Thanks in advance...
This should be a FAQ I was pulling my hair out trying to figure this out. I saw a lot of threads where people were asking how to change the triad or swap planes (for instance make the top plane the front plane) ..and there wasn't an easy answer. This was definitely the solution I was searching...