I got error 144. I have found on some site through google keywords:
-----------------------------------------------------------------
""""Dear Friends,
I have written a UEL for Strain Gradient Plasticity and is working well when i give Boundary condition as Concentrated force, But when i apply...
This is what i must do: (animation)
everything in this animated asembly must be simulated for results. Spring tension, forces on Rivets (points of contact between Rivets and spring), latch (the moving part with A number on it) is basically fixed, and frame on to po frame force is applyed...
so basically there is no need to additionally apply position constraints.
Therefore i must use this:
QUOTE: "Actual physical constraints, such as contact or tied surfaces, would be defined as normal in the Interaction module."
i must apply surface to surface contacts, fixed contact...
Hi,
i have successfully imported assembly from Solidworks to Abaqus. In Solidworks i have defined all mates as they should be. Question i have is, are the mates translated to abaqus with this assembly too?
in abaqus it says under model/assembly/instances (14) (total are 14), but there are no...
hi, i am stuck, and i need guidance.
Here is link to youtube. (a better way to explain this) :D
Spring problem:
http://www.youtube.com/watch?v=Zfmw9FK-9lw
then assembly problem:
http://www.youtube.com/watch?v=rA27ho1UR9w
question: how to make it work. Through mates? sketch mates?
I tryed...
hey, thank you for advices. I have found that, when i manualy set: under "connections" (contact set) with no penetration it give me that error. Probably because i have not defined it properly. What i did is, deleted all that manual connections (on my video at 3 seconds left on the "tree...
Hi, all. Recently i have started to do simulations in Solidworks 2011. At work i must simulate pressure/force momentum.. on one of our products. I am new at this, thus i came here for help.
Am i doing right? what is the procedure for this type of simulation. (look under project tree on video)...
