0,0 Origin promblem

[haggis]

Hi all,

I have a large plant layout made up of a number of x-refs we'll call A-Z. When the root drawing is opened, everything is fine. Here is the problem I'm having. If I start a new layout and open drawing A, then x-ref B,C,D and E, x-ref E lands way out in left field or where I'm located, is probably where the freeway is! However, if I open E first and x-ref A,B,C and D,everything is in place. Can anyone shed some light on this one?

Thanks in advance,

Haggis

 

[ajack1]

Is one layout set about a UCS and another the WCS? I know the defaults on these things drive me mad.

 

[haggis]

ajack1,

Thanks for the tip but using the WORLDUCS command on the various drawings shows me that the UCS and the WCS are coincident.

 

[CarlB]

The INSBASE setting for E must be other than 0,0.

 

[haggis]

CarlB,

INSBASE (new one on me) done the trick.

Thanks,

Haggis