10mm stainless steel I NEED HELP TO IMPROVE CUT!!!

[Lucas36]

Hi! I'm looking for solution how to improve cut on 10mm st/st. Like you can see on the photos top side is perfect but the bottom side is burn. WHAT would you change in cutting condition to looks better? Its use condition 5 for cut holes and 7 to cut shape of part, also after pirce is use condition 2 to start.(photo of cutting condition)

 

[drossfree]

looks like your focus is too deep and your speed is too slow. but a picture of your edge is what i need to see.

 

[Lucas36]

 

[laserkatana]

Do you have PGC ON? Can you check either page 2 or 3 of your condition screen to see if you have it? If you do have PGC what is the value? What about running the holes with the same condition as the outside?

 

[Lucas36]

Yes, the PGC value is 1.

 

[laserkatana]

Turn it OFF by replacing it with a 0 and see if the cuts on the holes get better.

 

[Lucas36]

no its doesn't help. Any others ideas how to set?