Feb 20, 2010 #1 pipelyer Petroleum Feb 20, 2010 10 Is it within code to weld a 2" Weldneck flange directly to the top of pipe (nps 8") csa z662-07 Code
Feb 22, 2010 Thread starter #3 pipelyer Petroleum Feb 20, 2010 10 More Info EuroPipe?? Upvote 0 Downvote
Feb 22, 2010 #4 dcasto Chemical Jul 7, 2001 3,570 You need a weld-o-let or a branch tee Upvote 0 Downvote
Feb 23, 2010 #5 europipe Chemical May 14, 2007 710 Like dcasto says, You need a piece of pipe(weld-in/on)or better a weldolet for a proper weld. That's not possible with a grinded flange. Greetings Upvote 0 Downvote
Like dcasto says, You need a piece of pipe(weld-in/on)or better a weldolet for a proper weld. That's not possible with a grinded flange. Greetings
Feb 23, 2010 #6 zdas04 Mechanical Jun 25, 2002 10,274 Take a look at the backside of a 2 inch flange, think there is room to put a welding rod in there when it is up against a pipe? David Upvote 0 Downvote
Take a look at the backside of a 2 inch flange, think there is room to put a welding rod in there when it is up against a pipe? David
Mar 2, 2010 #7 11echo Petroleum Jun 4, 2002 444 I bet ya that if you look at the "branch table" in the piping spec.s it'll show you'll be using a weld-o-let on a 600# line. Upvote 0 Downvote
I bet ya that if you look at the "branch table" in the piping spec.s it'll show you'll be using a weld-o-let on a 600# line.
Mar 10, 2010 Thread starter #8 pipelyer Petroleum Feb 20, 2010 10 Td Williamson Thread O Ring Flanges are designed for this purpose. Upvote 0 Downvote
Mar 12, 2010 #9 europipe Chemical May 14, 2007 710 And if You want a short connection try a padflange Upvote 0 Downvote
