3 points bending

[sigmacoder]

Hi everybody,
first of all, sorry for my bad english, i'm not a native speaker.
I'm a new member on this forum, and i wish i will find a lot of good people here and that i can contribute in a positive way.

i have a problem with simulation of 3 point bending of a plate. i dont know how can i applicate a line load in the center of the plate.

it's possible ? how ?

 

[IceBreakerSours]

Try some examples in the Benchmarks, Verification, and Examples manual. However, make sure you open the input files (.inp) and correlate what you see in the input files and ABAQUS/CAE.

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083

 

[sigmacoder]

thanks IceBreakerSours for your quick answer, but i dont understand what i should do with the .inp file ? i can't do that with the CAE interface ?

can you give me an example because i find nothing in the internet ...

 

[IceBreakerSours]

I repeat: Please begin going through the examples in the manuals. There is *no* need to start googling just yet. However, if you still wish to spend time on the internet, try this link:

http://www.ewp.rpi.edu/hartford/~er...Students/Nasser/AbaqusTutorial-BrownEN175.pdf

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083

 

[sigmacoder]

ok thanks for your answer i will see the examples of the manuals.