Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

3Dexperience Piping&Tubing - Use of Robot for Routes

Status
Not open for further replies.

fabianb

Aerospace
Jun 22, 2020
5
FR
Morning all,
I'm starting to pull my hair out a bit with the 3Dexperience Piping&Tubing workbench. In CATIA V5 I used to rely heavily on the compass to route runs. This was super efficient as I could quickly route a run along the desired path.

In 3Dexperience there doesn't seem to be an option to use the robot (aka compass in V5) to define the route geometry? Has anybody else come across this issue and found a quick way to use the new, in my opinion, super clunky user interface to run and adapt route geometries?

Thanks,
Fabian
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top