Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

4 Axis - angle limitation

Thread starter sebw
Start date Nov 13, 2017

Status: Not open for further replies.

Nov 13, 2017

sebw

Marine/Ocean

Hi, I need to create a simple 4 Axis CAM Operation (deck of a surfboard, including the lower part of the rail) where I need to limit the max angle of the 4th axis to a max of +/- 90°. I seem to have no luck in finding the right toggles...using NX2.
Any help would be greaty appreciated. Thanks!