Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

-48 Volt Adapter

Status
Not open for further replies.
rodneyb

rodneyb

Mechanical
Jun 26, 2001
30
Where can I find an adapter to take 110 VAC input and convert to -48VDC out put? Thanks...
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Suggestion: Try:
a) ELPAC W7248-D5 Allied stock no. 879-0429 with 100 to 250V, 47 to 63Hz imput, and 48VDC 1.5A output
with IEC 320 connector on its input
b) AULT SC102TA48038B01 Allied stock no. 298-1029
90 to 264VAC input, 15Watt, 48VDC 0.38A output
c) etc.
at 1-800-433-5700
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

bdn2004
  • Locked
  • Question
Does a 480D-600/346Y transformer have to be center tapped grounded if not utilizing the lower volt?
Replies
3
Views
100
che12345
che12345
Selva_51
  • Question
480V ungrounded Delta
Replies
19
Views
6K
mparenteau
mparenteau
power2engineer
  • Question
480V, 300KW, BESS System breaker ground fault trip 3
Replies
7
Views
450
waross
waross
H
  • Question
ABB REF615 Under-Voltage Function Block 27
Replies
3
Views
877
hbenafan
H
jmbelectrical
  • Locked
  • Question
Arcing fault at 480/277V panelboard, overcurrent protection, and grounding 1
Replies
17
Views
311
waross
waross

Part and Inventory Search

Sponsor

Back
Top Bottom